Fairs

Please visit us at one of the listed Trade Shows / Exhibitions – You will either meet us in our own booth or in the booths of our international factory representatives.

22. - 25. September 2010,
 EXPOMAC, Curitiba, Brazil


19. - 22. October 2010,
 Tekniska Mässan, Stokholm, Sweden


26. - 30. October 2010,
 EuroBLECH, Hannover, Germany


02. - 04. November 2010,
 FABTECH, Atlanta, USA

16. - 20. November 2010,
 PRODEX, Basel, Switzerland

Bevel Pro type FF

The Bevelling Machine type FF is available in 3 different models: Selection of the model is based on the specific application.

All the FF series models have an oscillating Grinding Unit which is positioned on a heavy support and can be tilted to adjust the bevel angle.

The material removal rate for the FF type machines is - depending on the tensile strength of the alloy - up to 80 cm³/min. All three models can handle material up to a thickness of 60 mm.

Edge and Bevelling Machine type FF 1

Models

Bevel Pro type FF1

Bevel angle 0° to -60° - This unit grinds the piece from the bottom side.
Work pieces move on conveyor rollers along the stationery Grinding Unit.

 

 

Edge and Bevelling Machine type FF 1

Bevel Pro type FF 2

Bevel angle 0° to 75°; This unit grinds the pieces from the top side.
Work pieces move on conveyor chains along the stationery Grinding Unit.

 

Edge and Bevelling Machine type FF 3

Bevel Pro type FF 3

Bevel angle 0° up to 60°; This unit grinds the pieces from the top side.
The Grinding Unit moves along the stationary table holding the work pieces.
This model is available in a table / grinding length of 1500 and 3000 mm (“UKF light”)

 

 

Edge and Bevelling Machine type FF 4, unlimited process length

Bevel Pro type FF 4

Bevel angle 0° up to 60°; This unit grinds the pieces from the top side.
The Grinding Unit moves along the stationary table holding the work pieces.
This model is available in a table / grinding length of 1500 and 3000 mm.

Unlimited process length because of C-shape side frames.

Modifications

In a modified version the FF 1 is used to grind Holland Profiles in shipyards to manufacture a precise bevel-geometry for the Laser-Hybrid-welding process.
This model is equipped with 2 grinding units creating a bevel including 2 angles in one pass.

To remove primer and other contaminants in the welding area additional grinding units can be added.